SATIN FINISH BATHROOM WOOD & CABINET PAINT

Update and protect old and worn bathroom wood including doors, cabinets, melamine, window frames, skirting boards, window sills and much more with Rust-Oleum Bathroom Wood and Cabinet Paint. With a durable smooth satin finish, it brings a new lease of life and colour to your dated and discoloured wood surfaces. The paint is self-priming, mould and algae resistant and dries in just 1 hour.

• Water-based with virtually no odour.

• No primer needed.†
• 10 year performance.*

• Durable, smooth satin finish.
• Mould and algae resistant.#

• Exceptional coverage.
• Highly concentrated.

• Colour-fast - will not fade.

*The paint film is designed to resist cracking, peeling & blistering for up to 10 years before first maintenance.

†Previously painted surfaces should be abraded and degreased prior to paint application.

#This product contains a biocide to protect the dry film from fungal & algal degradation. Freshly painted surfaces should be allowed to fully cure before subjecting to high levels of humidity. Not suitable for use in saunas or steam rooms. Once dried, the paint film is classed as a treated article & contains the surface biocides 2-Octyl-2H-isothiazol-3-one 0.24% & Terbutryn 0.192% by weight. Determination of the Resistance of Surface Coatings to Mould Growth (BS3900 Part G6) & Determination of Susceptibility to Algal Growth using IBRG Algal Protocol.

How to use Rust-Oleum Satin Finish Bathroom Cabinet Paint

Technical Data - Rust-Oleum Bathroom Wood & Cabinet Paint

Preparation: Ensure surface is clean, dry and free from contamination. Ensure any mould or mildew has been removed and if necessary, treat surfaces with a proprietary fungicidal solution. Surfaces must be completely dry before painting, a maximum moisture content of 12% is recommended. We recommend that bare softwood should be sanded before painting. If painting over hard, glossy existing paint or varnish abrade the surface before application. To ensure paint suitability test on a small inconspicuous area first.

Application: Prime any bare surfaces where stain bleed may occur, including knots and resinous timber such as hardwood or redwood. Stir thoroughly before use. The product may be applied by brush, roller or electric paint sprayer. If rollering, use a short to medium nap mohair roller. If spraying, paint should be diluted with water by 10-20% as required. Two coats are recommended. Temperature at time of application and during drying should be between 10° - 25°C. Coverage: Up to 14m²/L per coat.

Drying Time: Touch dry in 1 hour. Hard dry in 4 hours. May be over coated after 4 hours.

Clean Up: Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste paint.

Limitations: Temperature at time of application and during drying should be greater than 10°C. Not suitable for use on floors. Not suitable for areas where ponding water occurs, or surfaces that will be immersed in water.