Technical Data - Rust-Oleum Kitchen Tile Paint
Preparation: Ensure surface is clean, dry and free from contamination. Use sugar soap equivalent to remove all traces of contamination, rinse surface afterwards with water. If wax or oil has previously been used on the item, clean the surface thoroughly with white spirit. If painting over a hard or glossy or previously painted surface abrade the surface before application.
Application: Stir thoroughly before use. The product may be applied by brush or roller. If applying by brush, apply evenly, following the grain of the wood. If rollering, use a short to medium nap mohair roller. Two coats are recommended.
Coverage: Up to 14m²/ litre per coat. Coverage may vary depending upon method and rate of application and porosity of surface.
Drying Time: Touch dry in 1 hour. Hard dry in 4 hours. May be over coated after 4 hours. Full cure achieved after 7 days – take extra care during use in this time.
Clean Up: Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.
Limitations: Not for use directly onto metal. Not a stain blockingproduct. If unsure, test on an inconspicuous area before painting. Do not use abrasive cleaners to clean the product, use a damp cloth only. Some food items may stain the product, remove any spills immediately to stop this or minimize the effect. Not suitable for use on a bath or any surface regularly immersed in water. Temperature at time of application and during drying should be greater than 10°C. Whilst every effort is made to ensure the accuracy of colour, due to limitations of the print process, colour/finish shown is for guidance only.
Shelf Life: 2 years (unopened) from date of manufacture. (See base of can).
Disclaimer: The information contained herein is to the best of our knowledge true and accurate and is given in good faith but without warranty. It is our recommendation that a trial area is first coated to ensure the product is satisfactory to individual requirements. A copy of the appropriate health and safety should be consulted prior to use
