Technical Data - Rust-Oleum Bathroom Tile Paint (with Activator)
Preparation: For best results, ensure surface is thoroughly clean and free from contamination. Use sugar soap equivalent to remove all traces of contamination, rinse surface afterwards with water. Make good any repairs to failing grouting. Around sinks or wet areas it is advisable to apply the Bathroom Tile Paint first then apply silicone sealer over the paint where necessary (eg. between wall tiles and sink top).
Application: Apply when temperature is between 10 and 30ºC. Add the activator to the base and stir thoroughly until the mixture is uniform. Use the product within 5 days of mixing. The product may be applied by brush or roller. Two coats are recommended. Spray application is not recommended.
Coverage: Up to 14m2/ litre per coat. Coverage may vary depending upon method and rate of application and porosity of surface.
Drying Time: Touch dry in 1 hour. Hard dry in 4 hours. May be over coated after 4 hours. Full cure achieved after 7 days – take extra care during use in this time.
Clean Up: Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.
Limitations: Try to limit water contact during the first few days after application until paint achieves full cure. Not for use directly onto metal. Not a stain blocking product. If unsure, test on an inconspicuous area before painting. Do not use abrasive cleaners to clean the product, use a damp cloth only. Some items may stain the product, remove any spills immediately to stop this or minimize the effect. Not suitable for use on a bath or any surface regularly immersed in water. Temperature at time of application and during drying should be greater than 10°C.
Shelf Life: 2 years (unopened) from date of manufacture. (See base of can).
Disclaimer: The information contained herein is to the best of our knowledge true and accurate and is given in good faith but without warranty. It is our recommendation that a trial area is first coated to ensure the product is satisfactory to individual requirements. A copy of the appropriate health and safety should be consulted prior to use.
